How Do I Lay Self Adhesive Vinyl Floor Tiles?


When laying self adhesive vinyl floor tiles, the quality of the finish is entirely dependent on the quality of the preparation work youíve put in. Itís not difficult, self adhesive vinyl tiles are designed to be a DIY product but if you cut corners, eventually it will show and youíll regret it.

You will need: tiles, 6mm plywood, screws, PVA solution and brush, Stanley or craft knife, metal rule, scissors, tape measure, chalk line, pencil, card, rolling pin or tile roller, hair dryer or fan heater, time.

Buying the Tiles: Work out the area of the room you want done and add 10%. Now round it up to the next whole square metre. The extra will allow for odd cuts/wastage and any you muck up along the way. It will save on stress and postage if you donít have to order more near the end.

The Tiles: Put them in the room, in their boxes, where you intend laying them. Make sure the boxes are laying flat and not on their ends. Leave them there for two days to allow them to acclimatise. Make sure the room is warm. The adhesive will not work fully if the tiles are cold. 

Existing floor: First of all put in a layer of 6mm plywood. Make sure it is firmly attached to the floor underneath and all screw heads are countersunk. If you're laying on concrete, you will need to add a latex screed and then you will need to use extra adhesive. 

Seal the Ply: Not half as technical as it sounds. Make sure your screw heads are flush or below the surface of the ply, rigorously vacuum the ply, make sure there are no bits and pieces or dust still on the floor and then apply your sealant. Mix approx. 1 part of PVA wood glue to 5 parts of water and liberally coat your plywood with an old paint brush. Donít paint yourself into a corner and make sure you donít leave any bits on your dust free ply as you go. Leave to dry Ė wonít take very long.

Laying Tiles: Make sure the tiles and the room are warm before you start.

Best laying method is to find the mid point on each wall and using a chalk line, mark a cross at the centre of the floor (For detailed instructions Ė search Ďchalk lineí). In the angle described by the two crossing lines start sticking your tiles. Keep checking that youíre not trapping bits under the tiles Ė they will show through and cause uneven wear. Once youíve laid your tiles, go over the whole floor with a tile roller or if you donít fancy renting one of those, a humble domestic rolling pin and lots of effort!

You will probably find a few black marks and sticky bits as you go. This is just glue that has found its way into the front in the cutting process. It will wipe off with WD40 and kitchen towel.

Cuts: For straight cuts a metal rule and Stanley/craft knife is best. Score a line in the surface of the tile and then simply snap and slice through the backing paper. If you need to make a complicated cut Ė round the bottom of a door frame for instance Ė make a template with thin card, gradually snipping away until you get a good fit and then trace onto the tile. A good pair of scissors will easily go through the tile although itís best to snip at the tile in bits rather than try and follow the line with the scissors in one cut, if you find it heavy going try warming the tile further with a fan heater or hairdryer.

Door: Will the door still close? You might need to take it off and plane a bit off the bottom.

And thatís it. Providing you make sure that what you lay the tiles on is entirely flat, smooth, continuous and free from dust, you will get a perfect finish.